Industry News

Process flow of hollow glass

Views : 186
Update time : 2023-01-28 14:00:00

The middle of the hollow glass is filled with dry gas, and the frame is filled with desiccant to ensure the dryness of the air between the glass sheets. Can be selected according to the requirements of a variety of different performance of the glass original, such as colorless transparent float glass embossed glass, heat-absorbing glass, heat-reflecting glass, wire glass, tempered glass and frame (aluminum frame or glass strip, etc.), by bonding, welding or welding and made. Because two kinds of hollow glass in the process of many similarities, now on their common process analysis.

Hollow glass cutting material:

The original glass is generally colorless float glass or other colored glass, sunshade glass, toughened glass, laminated glass, the thickness is generally 3-12MM, the provisions of superior products, after passing the inspection can be used. Glass cutting can be done by hand or by machine, but it should be guaranteed to meet the size requirements. This process workers in the process of operation, should always pay attention to the glass surface should not have scratches, homogeneous endoplasm, should not have bubbles, slag and other obvious defects.

Hollow glass cleaning and drying:
Glass cleaning must use machine cleaning method, because manual cleaning can not ensure the quality of cleaning. It is necessary to check the glass without scratches before cleaning. In order to ensure the adhesion of sealant and glass, it is best to use deionized water. In addition, in order to ensure the recycling of water and save water resources, the water can be filtered to ensure long-term use. After cleaning, the glass should be inspected by light to check whether there are water beads, water stains and other stains on the surface of the glass. If there are water beads, water stains and other stains, it is necessary to adjust the running speed of the machine, heating temperature, air volume and brush clearance until the effect is intact. After washing the glass should be assembled into hollow glass within 1 hour, in addition to ensure that there is no friction between the glass and the glass, it is best to have semi-finished glass storage car, the glass between the pieces.

Related News